Model PFI -100 is designed for measurement of air flow in the pipes for industrial applications. It measures air Flow in the range of 0 – 100 LPM. Model PFI-100 works on 240 V AC Mains Supply. It measures air flow in ½” dia pipe. This air flow is indicated on 4 x 20 char LCD Display. It also generates 4 to 20 mA output signal, linearly proportional to air flow in LPM.

Low and High level alarms can be set within the full range of air flow. Air flow totalizer is also provided to integrate air volume in Liters for the preset time.

Model PFI-100 sensor circuit housed in the probe unit, is a robust, all solid state device working on Kings law. The length of interconnecting cable between probe unit and readout unit can be 3 meters long. Necessary ½” pipe couplings are provided to enable user install the probe in the air line.

Static Charge Controller is a mains operated electronic control unit and generates AC high voltage supply to drive ionisers. Different types of ionisers can be connected to the control unit.

Static Charge Eliminator SCE-1M

High Voltage : 5KV AC

Capacity : Can drive total of 4 Meter length of Hot Bar and cable. The efficiency of elimination decreases as the length of the cable increases.

Facilities : Provision to connect three nos. PARA Ionisers. Air-inlet and three air- outlets for ionisers requiring compressed air supply.

Safety Feature : Auto reset electronic switch disconnects H.V supply to ioniser in the event of overload due to :

Operator inadvertently touching sharp needle points of the ioniser.

An unlikely event of ioniser short circuiting or ioniser H.V current exceeding preset limit.

Power Requirement : 240V/120V, 50/60 Hz AC, 10VA max.

Mechanical Dimensions (in mm) : 150W X 150H X 210D

Weight : 5Kg approx.

GEDET is a versatile and sophisticated instrument for measurement of coatings of metal or alloy on substrates by electroplating or other methods. It is simple enough to be welcomed by operator of average skill when a large number of routine measurements on standard metallic coating are to be made. At the same time, it is sophisticated enough to be employed by a scientist for his investigation purposes on metallic and alloy coatings. It works on Coulometric principle. It has a very high accuracy and repeatability. It can measure thickness on flat or curved surfaces. GEDET also measures coating on known length of wire or pins using Acrylic cell which is supplied as an accessory.

Dual Channel Alpha Beta Counter model PNC-αβ is a micro-controller based, economical, stand alone, mains operated instrument for Dual Channel Nuclear Counting application for Alpha – Beta radiations. It is a versatile instrument designed to cater the counting application requirements.

Dual Channel Alpha Beta Counter Model PNC-αβ, uses Composite Detector (Plastic Scintillator and ZnS(Ag) Scintillator) for detection and measurement of alpha / beta radiation. High voltage required for the detector is generated in instrument. The load resistor for Photo Multiplier Tube (PMT) and the front end electronics for pulse processing circuits for the detector is housed in unit.

Dual Channel Alpha Beta Counter Model PNC-αβ, stores 1000 counts data (500 Alpha + 500 Beta) in a non-volatile memory. It generates formatted USB 2.0 output for transferring data to PC. USB male connector on the front panel is provided for transferring the data to PC. Support software for data transfer in Windows environment, is provided with system.

Model PNC-αβ is useful for radiation counting for Health Physics applications in radioisotope laboratories, nuclear reactors, nuclear power plants, nuclear medicine centers etc.

A Drawer Assembly to hold 1" dia or 2" dia filter paper is supplied as standard accessory. The detector mounts upside down on the drawer assembly such that myler face of the detector is just 2 mm above the sample filter paper.